Overview
- Authors:
-
-
Yusuf Leblebici
-
University of Illinois, Urbana-Champaign, USA
-
Sung-Mo (Steve) Kang
-
University of Illinois, Urbana-Champaign, USA
Access this book
Other ways to access
Table of contents (8 chapters)
-
Front Matter
Pages i-xvii
-
- Yusuf Leblebici, Sung-Mo (Steve) Kang
Pages 1-13
-
- Yusuf Leblebici, Sung-Mo (Steve) Kang
Pages 15-53
-
- Yusuf Leblebici, Sung-Mo (Steve) Kang
Pages 55-76
-
- Yusuf Leblebici, Sung-Mo (Steve) Kang
Pages 77-109
-
- Yusuf Leblebici, Sung-Mo (Steve) Kang
Pages 111-142
-
- Yusuf Leblebici, Sung-Mo (Steve) Kang
Pages 143-163
-
- Yusuf Leblebici, Sung-Mo (Steve) Kang
Pages 165-190
-
- Yusuf Leblebici, Sung-Mo (Steve) Kang
Pages 191-207
-
Back Matter
Pages 209-212
About this book
As the complexity and the density of VLSI chips increase with shrinking design rules, the evaluation of long-term reliability of MOS VLSI circuits is becoming an important problem. The assessment and improvement of reliability on the circuit level should be based on both the failure mode analysis and the basic understanding of the physical failure mechanisms observed in integrated circuits. Hot-carrier induced degrada tion of MOS transistor characteristics is one of the primary mechanisms affecting the long-term reliability of MOS VLSI circuits. It is likely to become even more important in future generation chips, since the down ward scaling of transistor dimensions without proportional scaling of the operating voltage aggravates this problem. A thorough understanding of the physical mechanisms leading to hot-carrier related degradation of MOS transistors is a prerequisite for accurate circuit reliability evaluation. It is also being recognized that important reliability concerns other than the post-manufacture reliability qualification need to be addressed rigorously early in the design phase. The development and use of accurate reliability simulation tools are therefore crucial for early assessment and improvement of circuit reliability : Once the long-term reliability of the circuit is estimated through simulation, the results can be compared with predetermined reliability specifications or limits. If the predicted reliability does not satisfy the requirements, appropriate design modifications may be carried out to improve the resistance of the devices to degradation.
